Easy Frame Install V3
How to install a Balustrade
GATES & FENCE PANELS
EASY FRAME
INSTALLATION GUIDE
Lorem ipsum about 3 or 4 sentences of intro text to be added here later. Lorem ipsum about 3 or 4 sentences of intro text to be added here later. Lorem ipsum about 3 or 4 sentences of intro text to be added here later.
Balustrade must comply with Australian Standard AS1170. Please check with your local Council regarding specifi c requirements.
Before digging check for underground services (gas, power, water, telephone)
“DIAL BEFORE YOU DIG” on 1100 (AUS) www.beforeudig.co.nz (NZ)
BALUSTRADE INSTALLATION GUIDE
STEP 2 – MARK AND CUT TO SIZE
Mark the horizontal rails at the required length...
they should be 300mm shorter
than gate width to allow for 2
gate corner pieces.
Mark the Vertical Rails at the required length, again allow 300mm for the corner pieces
GATES: To keep the mid-rail in the centre of the gate, trim an even amount off each end of vertical rails
FENCE PANELS: The 2500wx1200h kit does not include centre rail and lugs Check measurements and cut to the marked size
